ENGLISH
6
HOW TO OPERATE
BEFORE FIRST USE
1.
Follow the steps under CLEANING & MAINTENANCE before using this unit.
2.
Place the unit on a flat, level surface in a location that is protected from
direct sunlight and other sources of heat (i.e. stove, furnace, radiator). Ensure
there is at least six inches of empty space on all sides of the unit.
3.
Allow one hour for the refrigerant fluid to settle before plugging
the cord into an electrical outlet for the first time.
USING YOUR ICE CUBE MAKER
1.
Ensure the Water Drain Plug is inserted into the drain area.
2.
Open the Clear Lid to remove the Ice Basket and pour water into the Water
Resevoir. Keep the water level below the MAX level mark. If water levels exceed
the MAX level mark, drain any excess water by removing the Water Drain Plug.
3.
Replace the Ice Basket and close the Clear Lid.
4.
Press the ON/OFF button on the LED Control Panel to begin the ice-making cycle.
NOTE
: The unit will automatically begin making ice after 20 minutes
if user does not restart the unit after filling with water.
5.
Select the desired size of the ice cubes by pressing the SELECT button (S = small,
L = large). If the room temperature is lower than 60°F (16°C), it is recommended
to select the small-sized ice cubes in order to keep ice from sticking together.
6.
Each ice-making cycle lasts 7 to 15 minutes, depending on the size of the
ice cube selected and the ambient temperature of the room. In extremely
hot temperatures, ice-making time may vary considerably.
7.
While the ice maker is on, check the water level periodically. If the water pump is unable
to pump water, the unit will stop automatically and the Add Water light will illuminate.
8.
When the water level is low, press the ON/OFF button to turn the unit OFF, fill water up to
the MAX level mark and press the ON/OFF button again to turn ON the unit again.
NOTE
: The unit will automatically begin making ice after 20 minutes
if user does not restart the unit after filling with water.
9.
The unit automatically stops working when the Ice Basket
is full and the ICE FULL light will illuminate.
10. To ensure a reasonable hygiene level, change the water in the Water
Reservoir every 24 hours. When the unit isn’t in use, drain all water left
in the Water Reservoir. If the unit requires a deeper cleaning, refer to the
CLEANING & MAINTENANCE section for step-by-step instructions.
IMPORTANT NOTE:
In the event that the power is disconnected during the ice making
cycle or that the LED lights on the Control Panel are blinking, press the ON/OFF button
to stop the ice making cycle. Unplug the unit from the electrical outlet. Allow the
unit to sit for a few minutes to let it warm up and allow ice to fall from the evaporator
fingers. Empty the Water Tray and wait three minutes before restarting the unit.
DO NOT touch the Evaporator while the unit is in use or during the ice making
process. This could cause severe burns.
