Igloo IGLICEND40SS, Instruction Manual

ENGLISH

7

USING YOUR NUGGET ICE MAKER

1. 

Make sure that the rear drain is firmly plugged before beginning operation.

2. 

Pull out water tank to fill with water. Then put water tank back into the machine. 

 CAUTION: 

 Do not surpass the maximum water level on the MIN/MAX markings. 

 NOTE: 

Distilled water is best to fill the water tank. 

3. 

After plugging in the ice maker machine, press the "ON/OFF" Button and it will turn on. 

4. 

Ice machine will begin making ice nuggets. Check water level periodically.

NOTE: 

If water tank is near empty, the ice maker will stop automatically  

and the "ADD WATER" indicator light will turn on. Press the "ON/OFF" Button, fill up to 

the water level mark, and press the "ON/OFF" Button again.

NOTE: 

Nugget ice size will be relatively small for first use. This is a normal part of operation.

5. 

The ice maker will stop automatically once the machine is 

full and the "ICE FULL" indicator will turn on.

6. 

To ICE OUT from the machine, hold your container (cup, water bottle, 

etc.) below the ice dispenser and press the "ICE OUT" button. 

NOTE: 

Do not leave water in water tank for more than 24 hours 

to ensure that clean water is used to make ice.

NOTE: 

Noises such as clicking, gurgling, or knocking are normal when operating. 

IMPORTANT NOTE

:

  In the event that the power is disconnected during the ice making cycle 

or that the LED lights on the Control Panel are blinking, press the "ON/OFF" Button to stop 

the ice making cycle. Unplug the unit from the electrical outlet. Allow the unit to sit for a 
few minutes. Empty the Water Tray and wait three minutes before restarting the unit. 

HELPFUL TIPS

ADD WATER INDICATOR

 If the "ADD WATER" Indicator turns on, try the following: 
• 

Turn off the unit, add water, and press the "ON/OFF" Button again to restart the unit. 

• 

There may be too much ice. Turn off the ice maker, remove some ice from the ice basket. 

• 

Check and clean the water inlet with a straw brush

ICE FULL INDICATOR

If the "ICE FULL" Indicator comes on, try the following:
• 

Remove all the ice from the basket and press the "ON/OFF" Button to restart the unit.

• 

Remove any ice that may be blocking the ice chute with a small spoon.

NUGGET ICE STICK TOGETHER

• 

The ice cycle may be too long. Stop the ice maker, then restart it when the ice cubes melt.

• 

The water temperature in the water tank may be too low. Change the water in 

the water tank. The room temperature should be set between 45˚ F - 90˚ F.

• 

Press the "ICE OUT" button for 3 seconds, then release. After releasing the "ICE OUT" button, the 

auger will reverse its spin for about 1 second, which may help break up nugget ice clusters. 

• 

Gently tap nugget ice with a fork or spoon to break up clusters.

ICE IS FULL BUT INDICATOR LIGHT IS NOT ON

• 

Move the ice maker in a darker location so the infrared 

detection inside the ice maker can work properly.