REFRIGERATION LTD
Refrigerated Pastry Display Case
| www.igloorefrigeration.com
6
High ambient temperatures will cause the compressor to overwork.
Humidity may cause rust, condensation around glass or stainless steel and decrease the efficiency of the
unit.
3.3. Connection and start-up
To securely transport the equipment, the unit may be shipped partially disassembled. If the user received
the unit partially disassembled, perform the following operations:
1.
Screw the door handle. (Figure 3)
2.
Install shelf grips in perforated frame strips. (Figure 4/2) The frame may be a rotating frame or fixed
frame depending on the version of the unit.
3.
Stick silicon glass protective pads on shelf grips. (Figure 4/4)
4.
Place glass shelves on fixed grips. (Figure 4/1)
“JOR” series display cases are equipped with 5 regulated round or rectangular glass shelves
(depending on the option). The case with rotating frame is equipped with four upper glass
shelves and a bottom mirror.
The equipment should be cleaned right after unpacking and before turning it on. The unit should be cleaned
with warm water not exceeding 40°C with a neutral detergent. For washing and cleaning the equipment, it
is prohibited to use products containing chlorine and sodium varieties, which destroy the protective layer
and components of the equipment! Any residue of adhesives or silicone on metal elements should be
removed only with extraction naphtha (not applicable to items made of plastic). Do not use other organic
solvents.
When cleaning the unit, do not use water jet. The unit should be cleaned with a
moist cloth.
After the installation of the equipment at the destination location it should be left to
rest for at least 2 hours before turning it on (for devices with built in compressor) to
set the level of refrigerant in order to prevent problems with the start up.
WARNING: Keep out the cooling circuit from damage!
Turn on the main switch. (Figure 5/1)
The temperature on thermostat control panel is PRE SET. (Figure 5/3)
Turn on the light switch. (Figure 5/2)
Turn on the frame rotating switch. (optional)
