Igloo RAFAL B, User Manual

en

12

User manual RAFA

Ł

 B

www.igloo.pl

3.2. Connection and actuation

•  Unpack the device and remove the wooden platform from the basis Fig.2 (p.12)
•  Place the display cabinet on an even basis, which is hard enough, and then level it with feet.
•  Remove the protecting foil from elements of the device (f. ex.: from the inside of the device, display shelves, front 

fender beam)

•  If the user shall obtain a device partially disassembled to secure it during transportation, perform the following opera-

tions:

1.  Mount the hooks in rack strips Fig. 3 (p.12)
2.  Mount shelves on hooks Fig. 4 (p.13) 

Fig.2 Removing the wooden platform

Fig.3 Mounting the hook in the rack frame

1 - Unscrew the feet from the platform
2 – Remove the wooden platform
3 – Screw the feet in nuts welded to the frame of the device

1 – Screen of the rack
2 – Frame for mounting the hooks
3 – Hook (adjusted to three-degree regu-

lation of the suspension angle)

• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means of exten-
sion cords or dividers!)
• Turn the main switch on Fig. 5/2 (p.13), which will activate the thermostat, and then the aggregate of the device. 
• Set the temperature on the thermostat panel Fig.5/1 (p.13) (service details on p.17 or 18)
• Turn on the lighting switch Fig. 5/3 (p.13)

1

2

3

1

2

3

• The 

fi

 rst cleaning of the device should be provide right after unpacking, and before turning it on. The unit should 

be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning 
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protecti-
ve layer and components of the device! Any residue of adhesives or silicone on metal elements should be  remo-
ved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.

When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.

After installation of the device at the destination place it  should be left to rest for at least 2 hours before 
turning it on (for devices with built in compressor) to set the level of refrigerant in order to prevent problems 
with starting up the aggregate.

WARNING: Keep out the cooling circuit from damage!