-6-
www.igmtools.com
Operating instructions EN
Insert OVER-ARM into ELEVATING-BRACKET. Turn
wheel a few turns. Tighten LEVER.
Insert the extension tube (A) into cross slide vise,
push (B) hand-wheel into cross slide vise and
rotating while push-in, ensure the hand-wheel kit are
intermeshing with extension tube kit properly.
Lock the headless hex-screw in to cross slide vise
(C), the rotating the handle-wheel and insert it into
hand-wheel gear groove (D) to ensure the gears can
be rotating smoothly, lock the hex-screw to complete
the installation.
Install control-joint: To slip the end side of the
extension tube into swivel cone (A) and ensure the
alignment of the lever and extension tube centre line
(C) lock with 2 attached screw. (B)
NOTE:
The parallelism of the feeder rollers can be
affected by the angle of swivel cone.
Adjust the motor suspension: Loosen the lever(A) to
push motor suspension to the left side of the table
horizontally.
NOTE:
Motor suspension level can stable the feeder
and parallel to the worktable.
Power switch positioning: Due to the packaging and
shipping consideration, the power switch was placed
aside. Loosen the attached 4 Hex screw to move the
motor to the front for more convenient operation.
Machine body installation: Loosen the hex-screw(A)
and quick release grip (B), and take off the motor
clamp.
