-7-
www.igmtools.com
Operating instructions EN
Confirmation:
• Locked the hex-screw (A) and quick release handle
grip (B) to even the gap of two end. Loosen the quick
release lever to rotate the machine body.
• Feeder angle adjustment, Loosen the stand handle
(A) and lower the feeder to adjust the rollers and
worktable until them horizontally.(B)
• Feeder roller level positioning: Lower feeder to table,
alignment “slight off” is acceptable.
- offset by indendent suspension.
• Loosen the handle grip (A), adjusting the motor
suspension level (B)
• Loosen two attached screws(C), and adjust the
motor suspension angle (D).
To complete the installation: Confirm all the handle
and screws are locked properly.
6. OPERATION CONTROL
6.1 Stand
Over-Arm rotation:
Loosen lever. (A)
Over-Arm extension:
Loosen Lever (B),
