-9-
www.igmtools.com
Operating instructions EN
9. MALFUNCTION ASSISTANCE
9.1 Solution to problems
Malfunction
Cause
Repair
Cannot turn on
the machine
Damaged fuse
Replace the fuse (use a fuse with the same value)
The tape is not
completely covered
with the glue
The glue is not properly melted
Open the glue pot and check if the glue has
dissolved properly.
The amount of glue in relation
to the width of the tape is
improperly set
Increase the amount of glue with the control
knob. (see chapter 6.1.3)
Deformed tape
Use a tape of better quality.
The glue was applied poorly to
the banding roller
Turn on the feed and let the glue circle between
the applicator and the glue pot
The tape doesn‘t
hold on the
workpiece
The pressure roller isn‘t
perpendicular to the edge of the
workpiece
Adjust the angle of the support table so that it‘s
perpendicular to the edge (see chapter 6.1.2)
Overheating can degrade the
properties of the glue
Replace the old glue in the pot with the new one
The glue hasn‘t been heated to
the right temperature
Check the label on the glue and set the
temperature accordingly
The tape has twisted
while banding
The feed speed is slower than
the feed of the tape
Increase pressure on the workpiece
The tape is slipping
on the infeed roller
Dust or debris on the infeed
roller
Clean the infeed roller
The feed won‘t turn
on
The glue isn‘t melted enough,
the operating temperature
hasn‘t been reached so far
The motor can be turned on after reaching 12 °C
to ensure proper temperature for work.
Overheating
Malfunctioning temperature
control
Let a qualified electrician replace the
temperature detector
10. PROTECTION OF THE ENVIRONMENT
Protect the environment.
Your machine contains materials that can be recycled.
Please, let specialized institutions handle the machine.
11. ACCESSORIES (SPARE PARTS)
IGM Tape Holder for Edgebander DR500-BR300
142-BC25
IGM PD80 Edgeband Trimmer
142-PD80
IGM End Trimmer for Shaped and Straight Panels
M951-V
IGM Fachmann Edge Banding Hand Trimmer
M950-00001
IGM Worktable for Edgebander and Trimmer for
DR500-BR300
142-ST95A
IGM Straightline Edgebanding and Trimming Kit for
Worktable ST95A
142-ST97
Glue Technomelt KS224 for IGM Manual Edgebanders
- 5kg pack
M967-5
Glue Technomelt KS224 for IGM Manual Edgebanders
- 25kg pack
M967-25
IGM Vacuum Clamp One-sided, set
M964
IGM Lever Valve for Vacuum Clamp M964
M966-01
IGM Plastic T-splitter for Vacuum Clamp M964
M966-02
