-2-
www.igmtools.com
Thoroughly read this manual and follow the safety instructions provided!
Technical changes and typographical errors reserved!
Dear customer,
This manual contains important information and instructions for installation and proper use of the rounding-
chamfering router PD80.
This manual is part of the machine and is therefore not advisable to store it anywhere else than in the vicinity of
the machine so you or other persons operating the machine can consult it at any time.
Please read and follow the safety instructions!
Before the first use of the machine, please read this manual. It will make your work easier and you can
simultaneously reduce the risk of any mistakes, damage to the machine or personal injury. The design,
construction, images or content may slightly differ due to continuous development. Should you discover
any errors in the manual, please tell us about them at: podpora@igm.cz.
1. DECLARATION OF CONFORMITY
The undersigned: IGM nástroje a stroje s.r.o.
Address:
Ke Kopanině 560
Tuchoměřice, Praha-západ, PSČ 252 67
Czech Republic, EU
Tel. +420 220 950 910
Certifies
Product:
Edgeband Trimmer
Model:
PD80
Manufacturer: CO-MATIC Machinery Co., Ltd.,No. 473-16,
San Feng Road, Houli District, Taichung
City,Taiwan, R.O.C. 42156
We declare on our sole responsibility that the product
described in this manual is in compliance with the
following Standards: EN ISO 12100, EN ISO 13857, EN
349, EN 953, EN 60204-1, EN ISO 11202,
EN 55014-1, EN 55014-2 according to the provisions
of Directives 2006/42/EC, 2004/108/EC, 2006/95/EC,
2002/95/EC.
Signed: Ivo Mlej
Manager
CONTENTS
PAGE
1. DECLARATION OF CONFORMITY
2
2. WARRANTY SERVICE
3
3. SAFETY
3
3.1 Instructions
3
3.2 General safety instructions
3
3.3 Risks
4
4. TECHNICAL SPECIFICATION
4
4.1 Machine Description
4
4.2 Technical parameters
4
4.3 Supplied with
4
5. TRANSPORT, UNPACKING AND ASSEMBLY
4
5.1 Transport and Unpacking
4
5.2 Assembly (compilation)
4
5.3 Connection to power
5
5.4 Dust extraction
5
6. PREPARATION FOR OPERATION
5
6.1 Assembly of the Trimmer
5
6.2 Adjusting the bearing stop
6
6.3 Calibrating the trimming depth
6
7. OPERATION
6
7.1 Trimming of wide tape on the edge
6
7.2 Trimming a radius on the edge
6
7.3 Finishing an edge with a Radius Scraper
7
7.4 Trimming with a chamfer bit
7
8. MAINTENANCE AND CONTROL
7
8.1 Maintenance after work
7
9. MALFUNCTION ASSISTANCE
7
10. ENVIRONMENTAL PROTECTION
7
11. OPTIONAL ACCESSORIES
7
Operating instructions EN
