IGM Laguna CFlux3Tv2, Operating Instructions Manual

-8-

www.igmtools.com

Step 12: Secure the base of the foot pedal bar to the triangular support 

plate by holding the lower support plate vertically up against the foot pedal 

bar using hex bolts (2) 8 mm*1,9 mm, flat washers (4) 8 mm*OD18*2T 

and hex nuts (2) 8 mm. Follow the same steps for the opposite side. 

Step 13: Attach the two ends of the Octagon foot pedal to the nut on the 

foot pedal bar.

Step 14: Secure the topping to the nut on the foot pedal bar. Follow this 

step on the opposite side.

Step 15: Secure the topping with (2) M8*30mm hex bolts.

Step 16: Align the bolt hole on the movable supporting brace on the foot 

peddle bar with the bolt hole on the octagon foot peddle.

Step 17: Secure the movable supporting brace on the foot pedal bar with 

the octagon foot pedal using (2) 9 mm*21 mm. Make sure the bolt

head is on the inside of the octagon handle. Adjust the tightness of this 

bolt accordingly. If this bolt is too tight, the Octagon foot pedal will not 

work

smoothly. When too loose it will not pick up the Octagon drum.

Step 18: Secure the Octagon drum lid to the cyclone funnel using hex 

bolts (8) 8 mm*19 mm, flat washers (16) 8 mm*OD18*2T and hex nuts (8) 

8 mm. Make sure to first attach all the bolts on before tightening the bolts.

Step 19: Assemble the wheels to the Octagon drum. Take the four 7,6 mm 

wheels  and secure to Octagon drum base panel (N) using flat washers 

(8) 9 mm*OD23*2T and hex nuts (4) 9 mm. 

3HP Mobile Dust Cyclone Manual 

21

Step Fourteen:  Secure the topping to the nut on the foot pedal bar. Follow this 

step on the opposite side.

Step Fifteen:  Secure the topping with 

(2) M8*30mm hex bolts 

3HP Mobile Dust Cyclone Manual 

23

Step Eighteen: 

 Secure the Octagon drum lid to the cyclone funnel using

 (8) 

5/16”*3/4” hex bolts, (16) 5/16”*OD18*2t flat washers and (8) 5/16” hex nuts.. 

Make sure to first attach all the bolts on before tightening the bolts. Failure to do 

will result in the drum lid not being able to align with the drum. 

Step Nineteen:  Assemble the wheels to the Octagon drum. Take the (4) 3” 

wheels and secure to Octagon drum base panel (N) using

 (8) 3/8”*OD23*2t 

flat washers and (4) 3/8” hex nuts.Use the flat wrench provided to fasten tightly.

You will find a tag on the cone with 

the following warning. Take note 

and remove tag when you have 

completed this step. 

You will find a tag on the cone with the 

following warning. Take note

and remove tag when you have

completed this step.