-9-
www.igmtools.com
Step 23. Secure the lower triangular support plate to the base using (2)
5/16”*3/4” hex bolts and (2) 5/16”*OD18*2t flat washers. Follow the same
steps for the opposite side.
Step 24. Locate the two foot pedal bars provided. There is a left side and
right side. To identify the correct side, look for the protruding nut, circled
in red below. It should be facing upwards when you place the bars on the
floor.
Step 25. Ensure that the foot pedal bar is the correct side and slide the
Foot pedal bar into the opening on the lower upright support panel. Make
sure the end of the bar is on the inside of the triangular support plate.
Follow the same steps for the opposite side.
Step 26. Secure the top end of the foot pedal bar to support bracket using
(4) 5/16”*1-3/4” hex bolts, (8)5/16”*OD18*2t flat washers and (4) 5/16” hex
nuts. Make sure the foot pedal bar is pushed all the way to the end of the
support bracket (indicated by yellow arrows). Follow the same steps for
the opposite side.
Step 27. Secure the base of the foot pedal bar to the triangular support
plate by holding the lower support plate vertically up against the foot pedal
bar and securing the U channel provided onto the foot pedal bar using
(2)5/16”*1-3/4” hex bolts, (4) 5/16”*OD18*2t flat washers and (2) 5/16” hex
nuts from the inside out. Follow the same steps for the opposite side.
Step 28. Attach the cover plate over the foot pedal assembly. Secure
using (6) 1/4”*3/4” hex bolts and (6) 1/4”*OD19*2t flat washers. Follow the
same steps for the opposite side.
Step 29. Attach the two ends of the Octagon foot pedal to the nut on the
foot pedal bar.
Step 30. Secure the topping to the nut on the foot peddle bar using (1)
M8*30mm hex bolt. Follow this step on the opposite side.
Step 31. Secure the movable supporting brace on the foot peddle bar with
the octagon foot peddle using (2) 3/8”*21mm hex bolts. Make sure the
bolt head is on the inside of the octagon foot peddle. Adjust the tightness
of this bolt accordingly. If this bolt is too tight, the Octagon foot peddle will
not work smoothly. When too loose it will not pick up the Octagon drum.
Step 32. Secure the movable supporting brace on the foot peddle bar with
the octagon foot peddle using (2) 3/8”*21mm hex bolts. Make sure the
bolt head is on the inside of the octagon foot peddle. Adjust the tightness
of this bolt accordingly. If this bolt is too tight, the Octagon foot peddle will
not work smoothly. When too loose it will not pick up the Octagon drum.
