Short clicks move the cursor through 6 levels of brightness. While you are moving the rose cursor, you
see how the brightness of white scale changes. Higher position of the cursor causes higher
brightness. Confirm required brightness by 1-second push. The poi go into running mode, so you can
see the current brightness right away.
Watch a video guide of button operation for better
understanding:
(turn on English subtitles in Youtube settings)
To sum up the principal modes in operation with the button:
To turn the poi off, press and hold the button for 3 seconds. From running
mode, you will see standby mode, then brightness level scale, then the device turns off.
Turning off.
the poi: push the button for at least 1 second. You will see ascending gradient, then
the poi gets to Standby mode with blinking cursor;
Turn on
from selected timeline/image: short click the button (less than 0,5 second);
Run the poi
back to Standby mode: click the button and hold it for 1 second
(such delay protects from incidental clicks when you spin the poi);
Go out of Running mode
the poi push the button and hold it for 3-4 seconds until all lights fade away;
Turn off
in Standby mode: press and hold the button for at least 0,5 seconds.
As soon as the cursor shifts up, release the button.
Shift the cursor up
in Standby mode: press and hold the button for at least 1 second until
Battery level scale appears (red-to-green gradient), then release the button. The cursor shifts
down, you are in battery level mode. Click the button short to get back to Standby mode.
To go one more step down, hold the button until battery level scale appears.
Shift the cursor down
from any position of the cursor – just turn off the poi and turn it on
(works only if the poi is not connected to a power source. If otherwise, the cursor retains its
position after turning off and on);
Return to 1st position
rose
run any timeline, then click
the button and keep holding (around 3 seconds)
until the
cursor on the white scale appears.
Choose required brightness.
Set required brightness:
when you are in
Standby mode, push the button for 1 second. The
current battery level is displayed as a red-to-green
gradient. Full scale means 100% charge, half – 50%,
etc.
Check current battery level:
On the figure the poi is 90% charged.
