14
FLAME
FLAME button
: Makes flame effect
dimmer and brighter.
NOTE:
Flame effect stays on until power
button is turned off. Flame effect must be
on for heater to turn on.
1.
Press once
. Flame brightness effect
gets changing.
2.
Press again.
until desired setting is
reached.
COLOR
COLOR button
: Makes the color flame
effect changing.
NOTE:
color effect stays on until power
button is turned off. Color flame effect
must be on for heater to turn on.
1.
Press once
. Flame color effect gets
changing.
2. Press again until desired setting is
reached.
HEATER
HEATER button
: Turns heater on and off.
NOTE:
The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE:
To prevent overheating, the heater
fan will blow cool air for 8-10 seconds
before the heater turns on, and after the
heater turns off.
1.
Press once
. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2.
Press again
. Indicator lights up.
1500W heater turns on and blows hot air.
3.
Press again.
Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
Temperature Limiting Control
This appliance is equipped with a Temperature Limiting Control. Should the fireplace reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1.
Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3.
Inspect the fireplace to make sure no vents are blocked or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4.
With the POWER switch in the OFF position, plug the power cord back into the outlet.
5.
If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
•
Remote control uses two
AAA
batteries
(
Not Included
)
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
.
Dispose of batteries at your local hazardous material processing center.