3
⚫
Risk of
electric shock
!
DO NOT OPEN!
No user-serviceable parts inside!
⚫
ALWAYS
turn this appliance off before unplugging it from the outlet.
⚫
ALWAYS
disconnect
this unit from the
power
supply
before
performing any assembly or
cleaning, or before relocating the electric fireplace.
⚫
NEVER
leave this appliance unattended.
ALWAYS
unplug this fireplace when not in use.
⚫
ALWAYS
store this appliance in a dry location.
NEVER
use the fireplace if it has become wet.
⚫
NEVER
plug this appliance into an outlet that is
old
,
cracked
, or has any
loose wires or
connections
. Plugging this fireplace into a faulty outlet could result in
electric
arcing
within
the outlet that could cause the
outlet
to
overheat or catch
fire
.
⚫
ALWAYS
check your heater cord and plug connections with
each use
!
i)
MAKE SURE
the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can cause the outlet to overheat.
ii)
This fireplace draws more current
than small appliances.
Overheating
may occur even if
it has not occurred with the use of other appliances.
iii) During use
check frequently
to see if the
plug outlet or face plate
is
HOT
!
iv) If the outlet or face plate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.
⚫
The power cord supplied with the fireplace has three
prongs: two flat blades (live and neutral) and one
round pin (ground). If a 3-slot receptacle is not
available, an adapter
MUST
be used. The adapter
MUST
be
properly grounded
to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]
⚫
SAVE THESE INSTRUCTIONS!
Preparation
This product includes a
GLASS panel!
Always use
extreme caution
when handling
glass.
Failure to do so could result in
personal injury
or
property damage
.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included):
Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4
” wood drill bit, hammer.
