17
Figure 18
NA3446a
6.
Drive the machine slowly forward until the top edge
of the quick coupler is completely under the top
flange of the attachment [Figure 18].
NOTE:
Be sure the quick coupler levers do not hit
the attachment.
Figure 19
C221410a
7.
Tilt the quick coupler backward until the attachment
is slightly off the ground [Figure 19].
NOTE:
When leaving the operator’s seat to install an
attachment, tilt the attachment until it is
slightly off the ground.
This will cause the attachment mounting frame to fit
up against the front of the quick coupler.
8.
Turn the machine off and exit the machine.
(See Entering And Exiting The Machine on Page 16)
WARNING
GENERAL HAZARD
Failure to follow instructions can cause serious
injury or death.
Before you leave the operator’s seat:
•
Lower the lift arms and put the attachment /
implement flat on the ground.
•
Engage the parking brake.
•
Move all controls to the NEUTRAL / LOCKED
position to make sure the lift, tilt, and drive
functions are deactivated.
•
Stop the engine.
◂
W-3156
Figure 20
NA3448A
9.
Push down on the quick coupler levers until they are
fully engaged in the locked position [Figure 20]
(wedges are fully extended through the attachment
mounting frame holes).
If both levers do not engage in the locked position,
see your machine dealer or representative for
maintenance.
Summary of Contents for Auger 75 DDH
