11
OPERATING PROCEDURE WITH COMPACT
TRACTORS
Approved Compact Tractor Models And
Requirements
Box Blade
48
Box Blade
60
Box Blade
72
Tractor HP
18–30
26–65
35–65
The chart shows the approved box blade models for
compact tractors based on horsepower.
Warranty on this implement is void if used on a non-
approved carrier. Contact your Ignite Attachments
representative for a current list of compatible carriers.
Setting Up The Ballast
Install the correct ballast on the compact tractor before
installing the three-point box blade. See the compact
tractor Operation & Maintenance Manual for ballast
information.
Entering And Exiting The Compact Tractor
WARNING
INSTABILITY HAZARD
Failure to obey warnings can cause the machine to
rollover.
•
Use Roll-Over Protective Structure (ROPS) and
fasten the seat belt.
•
Install the correct rear ballast.
•
Do NOT exceed the Loader lift capacity.
•
Check tire condition and proper air pressure.
•
Use tires with the correct load rating.
◂
W-3043
See your compact tractor Operation & Maintenance
Manual for detailed instructions on entering and exiting
the machine.
Installing The Three-Point Implement
Always inspect the compact tractor three-point hitch and
implement three-point mounting before installation.
(See Daily Inspection on Page 10) .
WARNING
GENERAL HAZARD
Failure to obey warnings can cause serious injury or
death.
Obey all warnings on the machine and in the
manuals.
◂
W-2744
Figure 7
c138256a
1.
Move the drawbar (Item 1) [Figure 7] to the storage
position or remove (if necessary). See the compact
tractor Operation & Maintenance Manual for detailed
information.
The three-point hitch lower links must be set wide
enough to clear the implement mounting pins.
2.
Adjust the sway bars (Item 2) (both sides) to move
the lower links (Item 3) [Figure 7] as needed.
See the compact tractor Operation & Maintenance
Manual for detailed information on adjusting sway
bars.
WARNING
CRUSHING HAZARD
Contact with the machine can cause serious
injury or death.
Before backing the machine, look in all
directions and make sure no bystanders are in
the work area. Do not allow anyone between the
machine and the implement when backing up to
the implement for installation.
◂
W-2734
3.
Enter the compact tractor
(See Entering And Exiting The Compact Tractor on
Page 11) .
4.
Start the engine and release the parking brake.
