Chapter 2 Hardware
UBA Bill Validator Error Codes
LED Status
Error
Causes and Solutions
Red LED
Green LED
Flashes 1 x
ON
Boot ROM error
Change the CPU Board.
Flashes 2 x
ON
1. Incorrect external ROM
contents or empty program
2. No program in the external
Flash ROM
Flashes 3 x
ON
Internal RAM error
Flashes 4 x
ON
External Ram error
Flashes 1 x
OFF
Cash Box full
Empty the cash box and re-install
Flashes 2 x
OFF
Stacker Pusher Mechanism
fault (Transport Jam Type 1)
Stacker motor may be corrupted. Change the motor if
defective. A Stacker Encoder Board failure may have also
occurred. Check all harnesses and connectors. Exchange the
Stacker Encoder Board and/or CPU Board if required with a
known good board.
Flashes 3 x
OFF
Transport Jam Type 2
The ICB is disabled/cash box is active. An Exit Sensor Board
failure may have occurred. Check all harness and connecters.
Exchange the Exit Sensor Board and/or CPU Board if required
with a known good board.
Flashes 4 x
OFF
Stacker Encoder Signal fault
or a Validator Jam
A Stacker Encoder Sensor failure may have occurred. Check
all lenses for dirt or scratches. A Lower Sensor Board failure
may have occurred. Exchange the Sensor Board if required
with a known good board.
Flashes 5 x
OFF
Transport Motor speed error
The Transport Motor Speed Encoder does not detect motor
rotation or requires sensor adjustment. Check all harnesses
and connectors. A Motor or CPU Board failure may have
occurred. Exchange the Motor and/or CPU Board with a
known good board.
Flashes 6 x
OFF
Transport Motor failure
Flashes 7 x
OFF
Reserved
N/A
Flashes 8 x
OFF
Reserved
N/A
Flashes 9 x
OFF
Anti-Pullback Unit error
An Anti-Pullback Home Sensor Board and/or a Lower Sensor
Board failure may have occurred. Check all harnesses and
connectors. Exchange the Anti-Pullback Home Sensor Board
and/or Lower Sensor Board with a known good board.
Flashes 10 x
OFF
Cash Box error
Cash box not seated or not present. A Cash Box Sensor Board
failure may have occurred. Check all harnesses and
connectors. Exchange the Cash Box Sensor Board and/or
CPU Board if required with a known good board.
Flashes 11 x
OFF
Reserved
N/A
Flashes 12 x
OFF
Cheated
Cheat attempt detected.
Flashes 13 x
OFF
Centering Mechanism
Solenoid error
A Solenoid or an Upper Sensor Board failure may have
occurred. Check all harnesses and connectors. Exchange the
Upper Sensor Board with a known good board.
Flashes 14 x
OFF
Centering Mechanism error
A Centering Mechanism Home Sensor Board and/or CPU
Board failure may have occurred. Check all harnesses and
connectors. Exchange the Centering Mechanism Home
Sensor Board with a known good board.
Cobalt™ 27
69
Summary of Contents for Cobalt 27
