2. PRECAUTIONS
Every Dot Inspector is manufactured with the highest quality of workmanship. Please read the following
to information carefully to assure long-lasting operation with this instrument.
STOP
AVOID LOOKING DIRECTLY INTO THE LED.
STOP
AVOID LOOKING DIRECTLY AT THE SUN OR ANY BRIGHT LIGHTS WITH THE MAGNIFIER
AS IT MAY CAUSE SERIOUS DAMAGE TO YOUR EYES.
Turn off the instrument and remove the batteries if it is not being used for a long period of time.
Removing the batteries is to prevent possible damage due to leakage
!
!
The unit can be damaged if the polarity of the batteries is mistakenly reversed.
Remove the old dead batteries immediately to avoid battery leakage. Do not mix and match
batteries. Only use new, AAA Alkaline batteries as replacements.
3
Dropping or misuse of this device may cause serious damage.
!
!
!
Avoid operating in an area where the unit may be exposed to direct sunlight, high humidity or
extreme temperatures.
3. HOW TO USE
3.1 Magnifier Installation
The Dot Inspector is designed to allow you to quickly change the magnification. Ihara provides three
types of magnifiers -- Available in 20x, 30x and 50x.
1. Rotate the focus cap counterclockwise until it is removed.
2. Insert the magnifier halfway into the focus cap with slight pressure.
3. Position the focus cap on the Dot Inspector body and rotate it clockwise until it stops.
4. Press the magnifier down until the magnifier is properly seated.
3.2 Holding and Operation
The contrasting light enables the user to clearly view each Cyan, Magenta and Yellow dot, and the
overall image.
Cyan Images:
The Cyan key will enable the red LED.
Magenta Images: The Magenta key will enable the green LED.
Summary of Contents for Dot Inspector
Page 1: ...IHARA ...
