OPERATION
IC120 ENG
3-2
BEFORE STARTING THE ENGINE
1. Sit on the seat, adjust it to allow free lever operations,
and fasten the seat belt.
2. Make sure that the operation lock lever (1) is set at the
locked position.
3. Make sure that the travel lever (2) and dump switch (3)
are set at the neutral positions.
4. Insert the key into the engine key switch (4), turn it to
the ON position, and check the following:
Engine preheating starts automatically. Make sure
that the preheat lamp (5) is lit and goes out then.
The lighting time of the preheat lamp varies with the
water temperature.
Make sure that the engine oil pressure lamp (6) and
battery charge lamp (7) are on.
Make sure that the mark lamp of the parking switch
(8) is on.
Turn the light switch of the combination switch (9)
and make sure that the head lamps go on.
Turn the turn signal switch of the combination switch
(9) and make sure that the turn signal lamps go on.
Push down the horn switch of the combination
switch (9) and make sure that the horn sounds.
Ask IHI’s sales service dealer for repair services, if some
abnormality is found in the above check.
Locked
Release
