iHome Air iW4, User Manual

24

English

Safety Instructions

1.  Water and Moisture –

 The unit should not be used near water. For example: near 

a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet 
basement. 

2. Ventilation 

–

 The unit should be situated so that its location or position does not 

interfere with its proper ventilation. For example, it should not be situated on a 
bed, sofa, rug or similar surface that may block ventilation openings.  Also, it 
should not be placed in a built-in installation, such as a bookcase or cabinet, 
which may impede the flow of air through the ventilation openings.

3. Heat 

– 

The unit should be situated away from heat sources such as radiators, 

heat registers, stoves or other appliances (including amplifiers) that produce 
heat.

4.  Power Sources  –

 The unit should be connected to a power supply only of the 

type described in the operating instructions or as marked on the appliance.

5.  Power Cable Protection –

 Power supply cables should be routed so that they are 

not likely to be walked on or pinched by items placed upon or against them.  It is 
always best to have a clear area from where the cable exits the unit to where it is 
plugged into an AC socket. 

6. Cleaning 

–

 The unit should be cleaned only as recommended. See the 

Maintenance section of this manual for cleaning instructions.

7.  Objects and Liquid Entry – 

Care should be taken so that objects do not fall and 

liquids are not spilled into any openings or vents located on the product.

8 Attachments 

–

 Do not use attachments not recommended by the product 

manufacturer.

9 

Lightning and Power Surge Protection – 

Unplug the unit from the wall socket 

and disconnect the antenna or cable system during a lightning storm or when it 
is left unattended and unused for long periods of time. This will prevent damage 
to the product due to lightning and power-line surges. 

10. Overloading  –

 Do not overload wall sockets, extension cords, or integral 

convenience receptacles as this can result in a risk of fire or electric shock.

11.  Damage Requiring Service  –

 The unit should be serviced by qualified service 

personnel when:

A.     the power supply cable or plug has been damaged.
B.     objects have fallen into or liquid has been spilled into the enclosure.
C.     the unit has been exposed to rain.
D.     the unit has been dropped or the enclosure damaged.
E.      the unit exhibits a marked change in performance or does not operate normally.

12. Antenna –

 Do not connect an external antenna to the unit (other than that 

provided).

13.  Periods of None Use –

 If the unit is to be left unused for an extended period of 

time, such as a month or longer, the power cable should be unplugged from the 
unit to prevent damage or corrosion. 

14.  Servicing  – 

The user should not attempt to service the unit beyond those 

methods described in the user’s operating instructions.  Service methods not 
covered in the operating instructions should be referred to qualified service 
personnel.

Consumer Product Safety Guide

FCC Radiation Exposure Statement

FCC ID:   EMOIW4. IC: 986B-IW4

This equipment complies with FCC RF radiation exposure limits set forth for an 
uncontrolled environment. This transmitter must not be co-located or operating in 
conjunction with any other antenna or transmitter.

This Device complies with RSS-210 of the IC Rules; Operation is subject to the 
following two  conditions: 
1.      This device may not cause interference and   
2.      This device must accept any interference received, including interference that 
         may cause undesired operation

This device complies with FCC radiation exposure limits set forth for an uncontrolled 
environment and it also complies with Part 15 of the FCC RF Rules. Operation is 
subject to the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation.  (FCC15.19) 
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux 
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions 
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de 
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 
susceptible d'en compromettre le fonctionnement. 

The device meets the exemption from the routine evaluation limits in section 2.5 of 
RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian 
information on RF exposure and compliance. 
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 
2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir 
l'information canadienne sur l'exposition et la conformité de rf. 

This equipment complies with the limits for a Class B digital device as specified in Part 
15 of FCC Rules. These limits provide reasonable protection against radio and TV 
interference in a residential area. However, your equipment might cause TV or radio 
interference even when it is operating properly.  To eliminate interference you can try 
one or more of the following corrective measures:
•       Reorient or relocate the receiving antenna.
•       Increase the distance between the equipment and the radio or TV.
•       Use outlets on different electrical circuits for the equipment and the radio or TV.
•       Consult your dealer or an experienced radio/television technician if the problem 
         still exists.

Modifying or tampering with your system’s internal components can cause a 
malfunction and might invalidate the system’s warranty and void your FCC 
authorization to operate it.

The separation distance between the equipment and the user shall not be less than 
20 cm

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil 
numérique de la classe B est conforme à la norme NMB-003 du Canada.