iHome Hello Kitty Si-B62, Instruction Manual

Setting and Using FM Presets

The unit allows you to store up to 10 FM radio station presets
1.  Press and release the    

Power/Mode Button

 as needed until the FM indicator icon and current FM radio 

frequency appear on the display.

2.  Press the 

–

 or 

+ Buttons

 to tune the radio to the desired station (hold to scan for the next clear station).

3.  Press and hold the 

     Clock/Presets Button

 to setting mode (P01- P10 will flash 3 seconds), push the 

–

or 

+ Buttons 

to select the preset number (P01- P10) you wish to set. 

4.  Press and release the 

     Clock/Presets Button 

to confirm. Continue steps 2-4 until you have set up to 10 

preset stations.

5.  To listen to a preset FM station at any time, just push Clock/Preset Button on FM radio mode and cycle 

to the desired preset.

Using the 

Si-B62

9

P10

Using the 

Si-B62

10

P11

Setting and Using the Alarms

This unit has 2 separate alarms, each set the same way. Below we explain how to set Alarm 1.

To set alarm 2, follow the same steps using the     /

Alarm 1 Button

.

Alarms can only be set when unit is OFF.

Note

: each step must be completed while display is flashing or step will time-out with any changes saved.

1.  Press and hold the    /

Alarm 2 Button

 for 2 seconds until the hour display and AL1 alarm indicator flash.

2.  Press the  

–

  or  

+   Buttons

 to adjust the alarm time to the desired hour (hold for rapid setting).

  Make sure you set the correct AM/PM alarm time. The PM indicator appears on the left of the display. 

3.  Press the    /

Alarm 2 Button

 to confirm the alarm hour setting. The minutes will flash.

4.  Press the  

–

  or  

+   Buttons

 to adjust the alarm minutes to the desired setting.

5.  Press the    /

Alarm 2 Button

 to confirm the alarm time setting. The red indicator next to Buzzer will flash

6.  Press the  

–

  or  

+   Buttons

 to select the desired wake to alarm source: buzzer or FM radio. 

7.  Press the   /

Alarm 2 Button

 to confirm the alarm settings and exit alarm setting mode. 2 beeps will 

confirm clock setting is complete. The alarm indicator will remain on the display, showing the alarm is 

armed.

Previewing Alarms and Turning Alarms On/Off

Quickly press and release an 

Alarm Button

 to view the current alarm time and wake source. Press again to

turn the alarm OFF, indicated by the red AL1 or AL2 alarm indicator disappearing from the display.