iHome iH41, Instruction Manual

Using the iH41

Setting Clock

1. Set the

DST Switch

 located on the back of the unit to +1 to add one hour or to -1 to subtract an hour. 

When set to +1 the DST icon will appear.

2.  Press and hold the 

Clock Adj Button

 located on the back of the unit until the display flashes. Press the

Hour

 and/or

Minute Button

 to set the time. Hold the button for a few seconds to adjust rapidly. Remem-

ber to set the correct AM or PM. An icon below the time digits is the 

PM Indicator

.

3. Press the

Clock Adj Button

 again (or no button within 10 seconds) to exit the clock setting mode.

Using the Alarm

Setting the Alarm

1.  Press and hold the

Alarm Button

 until the alarm time flashes. Press the 

Hour

 and/or

Minute Button

 to 

set the alarm time. Hold the button for a few seconds to adjust rapidly.  Remember to set the correct AM or 
PM.

2.  The alarm will automatically arm after set alarm time and the alarm icon will stay on to indicate alarm is 

armed.

3.  Default alarm sound is iPod but if no iPod is docked or iPod cannot play for some reason or the playing 

sound level is too low, it will automatically switch to buzzer alarm.

Arming and Disarming Alarm (Turn Alarm Function On and Off)

1.  Once alarm is armed, press the

Alarm Button

 to disarm it. 

2.  Press the button again to arm the alarm again.

Resetting the Alarm to Come on the Next Day

When the alarm is sounding, press the 

Alarm Reset/Power On/Off Button

 to stop the alarm and reset it 

to come on the following day at the same time.

Snooze

Press the

Snooze/Dimmer Button

 after the alarm sounds. The alarm will be silenced and come on again 

about 9 minutes later. Snooze can be pressed several times during the 1 hour alarm cycle.

Sure Alarm

The iH41 has a sure alarm feature so if a backup battery is installed, the buzzer alarm will still sound in the 
event of power failure.

4