5
maintenance
1: unscrew
Using a phillip’s head screwdriver,
loosen all the screws of the bulb’s
clear casing. Turn the metal clips
away from the circular disc to release
the casing.
2: replace
Remove the halogen bulb from the
two-pronged slot and replace with a
new bulb. Place the circular disc back
in its original location and slide the
metal clips to secure the disc in place.
Tighten the screws to ensure a firm
hold.
NOTE: When replacing the bulb do not touch with bare hands as
touching the bulb will significantly reduce its life span.
3: adjust
To adjust the angle of the iHL31, use a
coin to loosen the oversized screw at
the base of the lamp. Hold the base
firmly in place and loosen the screw to
change the angle of the arm. Once
the angle is right, secure the screw to
ensure a tight fit.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
FCC Regulations
