iHome iHM45, Instruction Book

6

Setting the Time

1. Press the 

DST Button

 located on the back of the unit  to add one hour for daylight saving time (on) 

or to subtract one hour for standard time (off). The       icon will appear on the display to indicate
DST is on.

2. Press and hold the 

Clock Adj. Button

 for 2 seconds until the hour display flashes. Press the     or

--

Button

 until the current hour is displayed. Remember to set the correct AM or PM time (a PM icon

to the left of the time display is the PM indicator; there is no AM indicator).

3. Press the 

Clock Adj. Button

 again. The minute display will flash. Press the     or      Button until the

current minute is displayed. Hold for rapid advance.

4. Press the

       Button

 during time setting to toggle 12-hour or 24-hour display format.  Note that 

the PM indicator will not appear when using 24 hour display mode.

5. Press the 

Clock Adj. Button

 again to confirm the clock setting. You will hear 2 beeps indicating the 

clock time is set.

Clock Setting

1.  Connect  the included stereo audio cable to the output/headphone jack on your audio device and 

the other end to the 

aux in jack

 located on the back of the unit.

2. Press the      

Button

 on the iHM45. The Audio Indicator (   ) appears in the display.

3. Place your audio device in play mode. Use the transport controls on your audio device for

playing/pausing,  scanning and skipping tracks, etc.

4. Press the     or      

buttons

 on the iHM45 to adjust the system volume.

5. To turn off the unit, press the      

Button

 on the iHM45. Remember to turn off your audio device, 

too.

Note: If your audio device is in pause mode over 3 minutes the unit will power off automatically.
6. The Audio Indicator (   ) disappears.

Listening to Your Audio Device

iHM45 IB-080113_v5.ai 

9 

10/14/13

2:07 PM