4
INSERTING BATTERIES FOR MEMORY BACKUP
SETTING THE CLOCK
It is advisable to fit batteries (not supplied) in the battery compartment to prevent the loss of
the display time and settings during a power failure. During a power failure, the unit can save
the time.
1. Disconnect the radio from power.
2. Drive out the screw on the battery cover.
3. Remove the battery compartment door and insert 2 x AAA size batteries, matching the
polarity (+ and -) as shown in the battery compartment.
4. Replace the battery compartment door.
Note: When operating with batteries only, the display will be blank and the clock will only
remain accurate for a short period of time. The clock accuracy will decrease due to the voltage
drop of the backup batteries. It is important that the mains supply is restored as soon as
possible. If no backup batteries are installed or the power interruption is prolonged, you will
need to set the clock again.
1. Insert the the DC IN plug into the DC IN jack on the unit and insert the Adapter plug into AC
100~240V, 50/60Hz mains outlet. The clock time will appear on display.
2. If the PM indicator lights, it means the time is PM time, if the PM indicator is off, it means it is
the AM time.
3. While in OFF mode, press and hold the SET button, the hour digits will blink, press the or
button to set the correct hour digits. Press the SET button to confirm the hour setting.
4. The minute digits will blink, press the or button to set the correct minute digits.
5. Press the SET button again to complete the clock setting.
NOTE:
If the Batt low indicator blinks, it means there are no batteries in the battery compartment, or
the batteries are low.
SETTING THE ALARMS
1.) Press the
button to put the Radio into standby mode, the clock time will appear.
2.) Press the ALARM 1/ button once to select the Buzzer AL 1 mode, press again to select the
Radio AL1 mode, press the third time to cancel alarm setting.
3.) Press and hold the ALARM 1/ until the hour digits blinks, press the or
button to
adjust desired hour digits. Press the ALARM 1/ button to save the hour setting.
4.) The minute digits will blink, press the or button to adjust desired minutes. Press the
ALARM 1/ button to save the minute setting.
5.) The volume level will appear on display, press the or
button to adjust desired alarm
volume level. Press the ALARM 1/ button to save and finish Alarm 1 setting.
NOTE: Using the ALARM 2/ button and the same ways as above stated to set Alarm 2.
STOP THE ALARM RINGING
When the alarm rings, press the button to stop ringing.