iHome IP39, Instruction Manual

Listening to FM Radio

Setting up the Antenna

Extend the wire antenna fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

1. Press the 

radio/aux. in Button

 as needed to turn on the iP39 and cycle to FM Radio mode. The middle part of the 

display will show “FM” and the lower part of the display will show the currently playing station frequency.

2.  Press the      or      

Button

 to tune radio to a desired station. Press and hold the      or      

Button

  briefly to seek the next 

clear FM radio station. Holding      or      

Button

 (2+seconds) will rapid scan as long as button is held.

3.  Press the        or       

Button

 to adjust volume setting.  

4.  To turn off the unit, press the 

OFF Button

. iPhone/iPod will continue charging while in the dock.

Setting FM Radio Frequency/Range to Use iP39 in Other Countries

Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches 
the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US, 
you may skip this section.

1.  Make sure the iP39 is OFF (not playing in any mode).  Press and hold the 

Radio/aux Button

 for about 5 seconds until 

“FM” flashes in the lower part of the display. Press the      or      

Button

 to select your region (EU=Europe, JPN= Japan, 

AUS=Australia, CHN= China).

2. Press 

the 

Radio/aux Button

 again (or no button within 5 seconds) to exit the radio frequency setting mode.

7

Using the Aux Line-In Jack with Other Audio Devices

Using Dimmer

1.  When unit is not in an audio (radio, iPod or aux) or setting mode, press the      or      

Button

 to adjust LCD backlight bright-

ness.

The iP39 has an aux line-in jack that lets you play other audio devices through it.  

1.  Plug one end of a standard 3.5mm audio patch cord (not included) into the headphone or line-out jack on your audio 

device and the other end of the patch cord into the iP39 aux line-in Jack, located on the rear of the unit.

2. Press 

the 

radio/aux. in Button

 until “AUX” appears in the middle part of the display, indicating aux mode is active.

3.  Turn on and play your device (device must be controlled independtly of the iP39).

4. Press 

the 

Volume   

   or

      Button

 to adjust the system volume. Adjust the output volume on your device if needed. 

5.  To turn off the unit, press the 

OFF Button

. Please remember to turn off your device, too.

April 19, 2010