iHome IP49, User Manual

7

Listening to iPod/iPhone

Listening to FM Radio

Setting up the Antenna

Insert the FM Antenna plug into the Aux-in/FM Antenna Jack on the back of the unit. Extend the wire antenna fully for best 

reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the FM Radio

1.  Press the 

Radio/AUX Button

 as needed to turn iP49 on and toggle between FM radio and aux-in modes. Select FM 

Radio mode. The last selected radio station will play and the frequency will appear in the display.

2.  Press the      or    

  Button

 to tune radio to a desired station. Pressing and holding the      or    

  Button

  (2 sec. then 

release) will seek the next clear FM radio station. 

3.  Press the 

Volume    

    or 

      Button

 to adjust the volume setting.  

4.   If needed, move the 

radio mono/stereo switch

 located on back of the unit to mono to improve reception/signal.

5.  To turn off the unit, press the 

 Button

. iPhone/iPod will continue charging while in the dock.

Setting and using FM Presets

You can set and save up to 6 radio station presets in memory.
1. To set a station as a preset, enter radio mode. Press and hold the 

preset button

. A number will flash indicating the preset 

number being set and the accompanying frequency. Press the      or      

Button

 to change the station (hold as above for 

station seek). Press the 

preset button

 to confirm the station as a preset. To review your presets, press and hold the 

preset 

button

 until the display flashes, then press the     or      

Button.

 Press the 

preset Button

 again to exit preset mode.

1.  Select and place the insert for your iPhone or iPod model. Gently insert an already playing iPhone or iPod. The iP49 will 

automatically turn on and you will hear the music playing from your iPod/iPhone. 

Note:

 If the playing song/music loudness is too low on the iPod itself, the iP49 may not detect that the iPod/iPhone is in 

play mode. Press the 

       Button

 to play it.  

2.  Press the      or    

  Button 

to change iPod/iPhone track forward/reverse.

3.  When the iPhone/iPod is docked and in standby mode, press the 

      Button

 to play it. 

4.  When the iPhone or iPod is in play mode, press the 

      Button

 to pause play; press again to resume play.

5.   Press the BonGiovi 

 Button

 to activate the DPS active digital processing circuit. Press again to turn off.

6.  Press the 

Volume       

or   

    Button

 to adjust the iP49 volume.

7.  Press the 

eq Button

 as needed to cycle through treble and bass sound settings. Press the      or      

Button 

to adjust 

settings for best sound. 

8.  To turn off the unit, press the 

 Button

. Your iPhone/iPod will continue charging while in the dock if unit is connected to 

AC power. It will not charge when running on internal battery.