Install/Replace Backup Battery
The iP98 uses a backup battery system to provide continuous alarm operation and clock settings
in the event of a power failure. If the Battery Low Icon located on the right of the display is flashing,
it is time to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise
all settings may be lost during battery replacement.
Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries
as indicated.
We recommend the use of alkaline batteries for longer life
.
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.
Replacing iP98 Backup Batteries
4
Using the iP98
Radio
Setting up Antennas
a) Snap AM loop antenna into provided stand, then plug AM antenna cable into AM Loop Antenna socket on back of unit.
Move antenna 12” away from unit for best reception.
b) Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the Radio
a) Press the
Radio Button
to select radio play mode. Press as needed to select FM or AM radio band.
b) Turn the
Set Wheel
to tune radio to a desired station.
c) To program the current station as a preset, press and hold
Preset Button 1-2
until P1 flashes on display; press again for P2 and
allow to time-out (beep confirmation). Repeat steps a,b,and c for other preset buttons to preset up to 12 stations (6 AM, 6 FM).
To listen to a preset station at any time, simply press the desired preset button once or twice.
d) Turn the
Volume Wheel
to adjust iP98 volume up or down.
e) Press the
EQ Button
to select Treble, Bass, 3D sound effect or Balance. Turn the
Set Wheel
to adjust settings. EQ settings for
iPod and radio mode are independent.
f) Press
Button
to turn iP98 off.
Using the Line-in Jacks
a) Use an audio patch cord (available at
www.ihomeaudio.com
) to play nondocking iPods or other audio devices through the iP98
Line-in Jack (connect one end in the device’s line out or headphones jack, the other in the iP98 line-in jack).
b) To listen to your audio device, press the
Radio Button
until line-in is displayed, indicating line-in mode. Adjust the output volume
on your line-in device.
Using Sleep Mode
Sleep mode lets you sleep to your iPhone/iPod or the radio, gradually lowering the volume until the unit shuts off at the selected
time.
a) Press the
Sleep Button
to select an amount of time before the iP98 shuts off: 120, 90, 60, 30 or 15 minutes.
b) Turn the
Volume Wheel
to set the sleep volume (this volume setting is separate from your standard volume setting).
Using the Dimmer
a) Press the
Snooze/Dimmer Button
during normal operation to adjust brightness of LCD display. There are 8 levels of brightness
including OFF.
