11
English
Aux-in Mode
You can play an MP3 player or other portable audio device through the iW4 via the Line-in Jack.
1. Plug one end of an audio patch cord (available at http//:www.ihomeaudio.com) into the headphone or line-out jack on your device and
the other end of the patch cord into the iW4 Line-in Jack, located on the back of the unit.
2. Turn on the unit and press and release the
Mode Button
as needed until “Aux-in” appears in the lower part of display, indicating Aux-in
playing mode.
3. Turn on and play your device.
4. Press the
or Button
on the unit to adjust the system volume. You may need to adjust your device volume, too.
Remember to turn off your device when you are done playing it.
Sleep (bedtime audio auto power down timer)
Sleep mode lets you sleep to AirPlay, iPad/iPhone/iPod, or the FM radio, gradually lowering the volume until the unit shuts off at the selected
time.
1. Press the
Bedtime Button
to enter sleep mode. The Sleep Icon will appear on the display to indicate sleep mode. Sleep mode has a Gentle
Sleep feature which gradually lowers the volume. The unit will automatically turn off after the selected sleep time.
2. You can adjust the sleep timer from 120, 90, 60, 30, 15 minutes or OFF by pressing the
Bedtime Button
again.
3. When the display changes back to show the real time, pressing the
Bedtime Button
once will show the sleep time remaining. Pressing it
again will change sleep time to next lowest increment.
4. iW4 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the alarm volume. Press the
or Button
on the unit to adjust the system sleep volume. The sleep volume will remain at that level the next time you enter sleep
mode until controls are changed.
5. To stop listening at any time, press the
Power Button
on the unit to turn it off.
FM Radio Mode
Setting up Antennas
Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the FM Radio
1. Press and release the
Power
Button
to turn on the unit, then press and release the
Mode Button
as needed to cycle through AirPlay,
iPod, FM radio and Aux-in modes.
2. When the FM mode is selected, press the
+ or - Button
to tune the radio to a desired station. The current radio frequency appears in the
lower right of the display. Press the
+ or - Button
for a few seconds to scan for the next clear station.
3. To memorize a station as a preset:
A. Press the
Presets Button
as needed to step through the 6 presets (P1 - P6) to the number you wish to assign, and then hold the
Presets
Button
until the selected preset number begins flashing in the display.
B. Press the
+ or - Button
to tune the radio to a desired station. Hold briefly to have the radio autoscan/search for the next clear station.
C. Press the
Presets Button
to confirm the setting, two confirmation beeps will confirm the setting and the preset number you wish to
assign. Repeat steps A-C to preset up to 6 stations.
4. To listen to a preset stations, press the
Presets Button
to choose the desired preset.
5. Press the
or Button
on the unit to adjust the system volume.
World Radio Band Selection for your Region
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches the standards
in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US, you may skip this section.
1. Make sure the unit is OFF (not playing in any mode). Press and hold the
Mode Button
for about 5 seconds until “Radio xxx” appears in the
lower part of display. Press and release the
+ or - Button
to set the “xxx” to your region.
2. Press and release the
Mode Button
again (or no button within 10 seconds) to exit the radio frequency setting mode. Two beeps will
confirm radio frequency setting.
Summary of Contents for iW4
Page 26: ...www ihomeaudio com...
