9
English
Gentle Wake Timer
The iW4 has a customizable “Gentle Wake” volume control for Quick Nap and dual Alarms. When an alarm sounds, the volume will gradually
increase from 0 to the specified Wake Volume over the Gentle Wake duration (OFF, 1-10 minutes). To adjust the Gentle Wake Timer:
1. Press and hold the
Wakeup Button
, then press and release the
+ or - Button
to o cycle from 1-10 minute increments or Gentle Wake OFF.
2. Press and release the
Wakeup button
again (or no button within 10 seconds) to exit the Gentle Wake setting mode (default is 1 minute).
Alarm Skip
If Alarm 1 or Alarm 2 is active, press the
Wakeup/Alarm Skip Button
to skip the next pending alarm time. Display will show “ALM 1 SKIP” or
“ALM 2 SKIP” (whichever is set to sound first) until the specified alarm time is passed and iW4 returns to normal alarm programing with Alarm
Skip deactivated. Press the
Wakeup/Alarm Skip Button
to deactivate Alarm Skip. NOTE: Alarm Skip can only be activated after a sounding
alarm is turned off or reset.
Replacing Sure Alarm Clock Backup Battery
The unit comes with 1 CR2450 back-up battery installed to provide continuous alarm operation and clock
settings in the event of a power failure. Remove the battery pull tab before use. When the Battery Low Icon
located on the lower right of the display is flashing, it is time to replace the back-up battery. The battery
compartment is located on the bottom of the unit.
1. Use a Phillips screwdriver to remove the battery compartment cover located on the bottom of the unit.
2. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery
replacement.
3. Insert 1 CR2450 battery checking that the + side is facing you. Replace the compartment door.
Note: Make sure you dispose of battery properly (see your local regulations).
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to
water, fire, or high temperatures. Do not place loose batteries in a pocket, purse, or other container contain-
ing metal objects, mix with used or other battery types, or store with hazardous or combustible materials. Store in cool, dry, ventilated area.
Follow applicable laws and regulations for transport and disposal
Quick Nap Alarm
Nap mode lets you set an alarm separate from the Alarm 1 and Alarm 2 settings. The nap wake to source by default is the iPod alarm. If
music is playing in any mode when the nap alarm is set to sound, the music will be muted and a tone alarm will sound.
1. Press the
Nap Button
located on the top of the unit as needed to adjust the nap timer for 5, 10, 15, 20, 30, 45, 60, 90 or 120 minutes or OFF.
2. When the display changes back to show the real time, pressing the
Nap Button
once will show the nap time remaining. Pressing it again
will change nap time to the next highest setting.
Display Dimmer
During normal operation, press the
Snooze/Dimmer Button
to control the brightness of the LCD display.
Sure Alarm
The unit has a sure alarm feature so the buzzer alarm still sound in the event of a power failure, if the backup battery is installed (see below).
If your iPad/iPhone/iPod has no sound for 35 seconds or is not present, the unit will switch to a tone alarm automatically.
Hardware Reset
To Reset the iW4 speaker:
1. Disconnect the iW4’s AC power and remove the battery backup.
2. Wait 30 seconds and then re-install the battery backup and re-connect the iW4’s AC power.
Replacing Backup Battery
Summary of Contents for iW4
Page 26: ...www ihomeaudio com...
