iHome SMARTDESIGN iC16 series, Instruction Manual

6

Note: In order for the alarm to operate you must install the 4 "AA" batteries or have the AC adaptor 
connected. The CR2032 back up battery will maintain the time and alarm settings but it will not turn 
on the alarm.
This unit features Gentle Waking, which gradually increases the volume of the alarm.

Setting the Alarm

1.  Press and hold the         

Button

 until the hour display flashes. Press the       or      

Button

 until the 

desired alarm hour is displayed. Remember to set the correct AM or PM time, indicated by PM on 
the display; there is no AM indicator.

2. Press the 

     Button

 again, then press the      or     

Button

 until the desired alarm minute is  

displayed.  

3. Press the 

     Button

 again to exit the setting mode. You should hear 2 beeps indicating the alarm 

is set.

Note: Once you set the alarm time, the alarm will be automatically armed, indicated by the       icon. 
To disarm the alarm, press the        

Button

. The      icon will disappear and the alarm will not sound at 

the set time. 
Note: Make sure to adjust volume level for a comfortable wake up volume.
4.  When the alarm is sounding, the         icon will flash. 
  • To snooze during the alarm, press the 

Snooze/Dimmer Button

. The alarm will be silenced for 9   

  minutes, then come on again.

  • To turn the alarm off and reset it to come on the next day, press the       

Button

. 

5.  If the alarm is not turned off once it sounds, it will play for one hour then turn off automatically. 

This cycle will repeat every 24 hours unless the controls are changed.

Alarm Operation