Astria.us.com
126753-01M
15
LOG PLACEMENT FOR Mission42TMN (F0865, F0867) MODELS
1. Place large back log (log 1) onto grate making sure notches rest
over grate
(see
Figure 26
).
2. Insert lower end of log 2A between first two grate fingers and
position upper end into notch on front of log 1. See
Figure 26
.
Place log 2B on front right side of grate as shown in
Figure 26
.
3. Place log 3 into notch on top left of log 1, resting lower end on
left two grate fingers
(see
Figure 27
)
.
4. Place upper end of log 4 into notch on log 1 as shown in
Figure
27
. Rest lower end of log 4 on middle grate finger as shown in
Figure 28
.
5. Place upper end of log 5 into notch on top inner right of log 1
(see
Figure 28
)
. Rest lower end of log 5 on middle grate finger
as shown in
Figure 29
.
6. Place log 6 into notch on top right of log 1
(see
Figure 28
)
. Rest
lower end of log 6 on top of log 2B
(see
Figure 29
)
.
As an option to enhance the look of the hearth, you may place the
volcanic stone provided around front and sides of burner pan.
NOTE
: It is important to ensure proper log placement per the manual
when installing these units. Verify pilot flame is not obstructed. See
Inspecting Pilot and Burner Flame Patterns on
Page 19
.
INSTALLATION
Continued
Figure 26 - Installing Logs 1, 2A and 2B
Figure 27 - Installing Logs 3 and 4
Figure 28 - Installing Logs 5 and 6
Figure 29 - Logs Installed for 42" Models
Log 2A
Log 2B
Log 1
Notch
1
J7242
Log, Rear 27"
2A
J4245
Log, Top 11"
2B
J4262
Log, Fire Pit Rnd "Y" 15-3/4"
3
J4244
Log, Y Top Split 13-1/2"
4
J4261
Log, Firepit Split 15-3/4"
5
J4243
Log, Top Split 16"
6
J4242
Log, Top Round 11-3/4"
1
3
4
5
6
2
A
2
B
1
2
B
3
4
Log 6
Log 5
Notch
Log 4
Log 3
Notches
1
2
B
2
A
2
A
NOTICE: Do not put volcanic stone inside the burner
pan or around the air mixer fitting. Placing volcanic
stone inside the burner pan or blocking the openings
of the propane/LP air mixer could cause performance
problems.
