901176-00 NC
14
ihp.us.com
Grand Canyon Gas Logs, LLC|3515 E. Atlanta Ave. Phoenix, AZ 85040| (602)344.4217
Remote Operations
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to
accept the transmitter security code upon initial use, if batteries are replaced, or if a replacement transmitter is
purchased from your dealer or the factory. In order for the receiver to accept the transmitter security code, be sure
the slide button on the receiver is in the REMOTE position; the receiver will not LEARN if the slide switch is in the
ON or OFF position. The LEARN button in located on the front face of the receiver; inside the small hole labeled
LEARN. Using a small screwdriver or end of a paperclip gently press and release the black LEARN buttoninside
the hole.
When you release the LEARN button the receiver will emit an audible “beep”. After the receiver emits the
beep press the transmitter ON button and release. The receiver will emit several beeps indicating that the
transmitter’s code has been accepted
into the receiver.
