INNOVATIVE HEARTH PRODUCTS • KITS AND ACCESSORIES • BLOWER KIT (MODEL FBK-250)
2
NOTE: DIAGRAMS AND ILLUSTRATIONS NOT TO SCALE
BLOWER
JUNCTION
BOX
ELECTRICAL
OUTLET
BLOWER KIT INSTALLATION FOR MULTI-OPEN DIRECT VENT FIREPLACE
(Corner Right)
BLOWER MOUNTING TABS
MODESTY
PANEL
CONTROL
MODULE
VIEW A
FIGURE 8
USE MODULE
HOLES 1 AND 2
(SEE FIGURE 8)
12” MINIMUM FIELD PROVIDED
EXTENSION CORD
BLOWER MOUNTING TABS
BLOWER
JUNCTION
BOX
ELECTRICAL
OUTLET
CONTROL MODULE
BLOWER KIT INSTALLATION
D-400, MDT3328 AND MDR3328 MODELS FRONT-OPEN DIRECT VENT FIREPLACE
TOP VIEW
(Millivolt Connection shown)
Use Module Holes 1 and 2
For Electronic Units (See Figure 8)
(Some units may need
these holes field-provided)
Use Module Holes 1 and 3
For Millivot Units
(See Figure 8)
Holes Shown are Cabinet
Flange Holes
VIEW A
FIGURE 8
Figure 4
Figure 5
BLOWER MOUNTING TABS
BLOWER
JUNCTION
BOX
ELECTRICAL
OUTLET
CONTROL MODULE
BLOWER
MOUNTING
TABS
BLOWER
JUNCTION BOX
ELECTRICAL
OUTLET
BLOWER KIT INSTALLATION FOR MULTI-OPEN DIRECT VENT FIREPLACE
(See-through, Peninsula, Corner left)
MODESTY
PANEL
CONTROL
MODULE
VIEW A
FIGURE 8
USE MODULE
HOLES 1 AND 2
(SEE FIGURE 8)
BLOWER MOUNTED
HERE ON MPD35ST
MODEL
BLOWER MOUNTING TABS
BLOWER
JUNCTION
BOX
ELECTRICAL
OUTLET
BLOWER KIT INSTALLATION FOR B-VENT FRONT-OPEN FIREPLACE
TOP VIEW
CONTROL MODULE
VIEW A
FIGURE 9
CONTROL MODULE MOUNTING TABS
CAUTION:
ROUTE BLOWER ELECTRICAL CORDS, SO THAT THEY ARE POSITIONED
WELL AWAY FROM THE ROTATING BLOWER PARTS
Figure 1
Figure 2
Figure 3
Control compartment door, access door/
panel, facade & modesty panel location
BLOWER KIT INSTALLATION FOR FRONT-OPEN DIRECT-VENT FIREPLACE, TOP VIEW
VIEW A
FIGURE 8
USE MODULE
HOLES 1 AND 2
(SEE FIGURE 8)
VIEW A
FIGURE 8
6.
Elite-2 Series Fireplaces - Remove the modesty panel as follows:
lift the modesty panel by the tab on the panel’s right end, pull the right
end of the panel away from cabinet and then pull the panel diagonally
out of the corner post slots on the left side of the unit. Remove the
modesty panel carefully, so that none of the wires become loose or
disconnected.
7.
Front-open direct-vent and B-vent units -
Slide the blower assembly through the front opening to the middle
rear area of the cabinet base. Position the blower assembly so that
the tabs (located on the cabinet base) are seated in the notches of
the blower bracket. Then bend the tabs over to secure the blower
assembly. See
Figure 1
, direct-vent models;
Figure 3
, B-vent mod-
els. For Compass and DRL2000 models, if unit is installed into a
wall and front or side access panels are not removable, please see
instructions in installation manual.
BLOWER KIT INSTALLATION FOR MULTI-OPEN DIRECT-VENT FIREPLACE
(See-Through, Peninsula, Corner Left)
BLOWER KIT INSTALLATION FOR B-VENT FRONT-OPEN FIREPLACE
TOP VIEW
BLOWER KIT INSTALLATION FOR MULTI-OPEN DIRECT-VENT FIREPLACE
(Corner Right)