SuperiorFireplaces.us.com
900463-01E
25
Figure 37 - Control Knob, Igniter Button and
Remote Selector Switch
Selector
Switch
Control Knob
in OFF Position
Flame
Adjustment
Knob
Igniter
NOTE
: The burner may light if hand-held remote
was on when selector switch was last turned off.
You can now turn burner on and off with hand-held
remote control unit.
IMPORTANT
:
Do not leave selector switch in the
REMOTE or ON position when pilot is not lit. This
will drain the battery.
NOTE
: Do not hold hand-held remote for a long
time. Body temperature will affect its operation in
the AUTO mode.
TO TURN OFF GAS
TO APPLIANCE
REMOTE READY MODELS
OPERATION
Continued
1. Turn control knob clockwise
to the OFF
position.
2a. Set switch in the OFF position.
2b.
If Using Optional Hand-Held Remote:
Set
selector switch in the OFF position to prevent
draining battery.
3. Close equipment shutoff valve
(see
Figure 15,
Page 15
).
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting In-
structions
,
Page 23
.
2. Press control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through 11,
Lighting Instructions
,
Page 23
.
OPTIONAL HAND-HELD
REMOTE OPERATION
NOTE
: All remote control accessories must be pur-
chased separately (see Accessories,
Page 40
). Fol-
low instructions included with the remote control.
NOTICE: You must light the pilot before
using the hand-held remote control
unit. See
Lighting Instructions
on
Page 23
.
After lighting, let pilot fl ame burn for about one
minute. Turn control knob to ON position. Adjust
fl ame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE posi-
tion
(see
Figure 37
).
WARNING: If you do not follow
these instructions exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
FOR YOUR SAFETY
READ BEFORE LIGHTING
VARIABLE REMOTE MODELS
OPERATION
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the ap-
pliance area for gas. Be sure to smell next to
the fl oor because some gas is heavier than
air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fi re department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don’t try to repair
it, call a qualifi ed service technician or gas
supplier. Force or attempted repair may result
in a fi re or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
