Operation
2017-09-06
213
In order to switch to a local source, proceed as follows:
1. If you are not in the
Switch
menu of the OSD, start Command Mode
with the 'Hot Key' (see Chapter 5.1, Page 55).
2. Press <o> to open OSD.
You will see a list of all available CPUs as a start menu.
3. Switch to the CPU in the
Local CPU
list.
The switching operation to the local source will be performed
immediately.
The local source (computer, CPU) will be only shown in the OSD, if the
connected CON Unit includes the option for a local connection.
As an alternative, the following keyboard commands are available to
switch to the local source:
Function
Keyboard Command
Switching to extender connection
<'Hot Key'>, <k>, <1>, <Enter>
Switching to extender connection 2
(only with redundant CON Units)
<'Hot Key'>, <k>, <2>, <Enter>
Switching to the local source
(computer, CPU)
<'Hot Key'>, <l>, <Enter>
Pos: 128 /806-IHSE/Betrieb/480_Multi-Screen_Kontrolle/480_Multi-Screen-Kontrolle @ 8\mod_1360600488238_6.doc @ 71072 @ 2 @ 1
