Draco tera
198
2017-09-06
Pos: 119 /806-IHSE/Betrieb/Bedienung über HotKeys/480-xx/Scan-Modus @ 7\mod_1309940746290_6.doc @ 53508 @ 3 @ 1
6.1.2 Scan Mode
Scan Mode enables fast switching between video signals from different
CPUs registered as favorites without continuously using the 'Hot Key'.
Switching between two video signals can even take place within one
frame.
1. Start command mode with the 'Hot Key'.
Shift
and
Scroll
LEDs on
the keyboard will flash, if command mode is activated.
2. Press the key <Left Shift> and hold it down. You can now enter the
index numbers of the various CPUs from the list of favorites with the
keyboard and immediately switch to the video signal of the respective
CPU after entering the index number.
3. Leave Scan Mode by pressing <Left Shift> + <Esc>.
Optimal results can be achieved by the use of as identical resolutions as
possible. This contributes to a smooth and seamless function of the scan
mode.
Pos: 120 /806-IHSE/Betrieb/Bedienung über HotKeys/480-xxC_Funktionstasten <F1> - <F16> @ 8\mod_1345793800423_6.doc @ 68021 @ 3 @ 1
6.1.3 Function Keys <F1>–<F16>
In Command Mode you can retrieve the macros 1–32 with the function
keys <F1>–<F16> on the connected standard keyboard instead of the
special macro keyboard.
Executing macros 17-21 is realized by the simultaneous use of the
key <left Shift>.
The stored command sequence for the appropriate function key is
executed and Command Mode is left immediately.
It is not necessary to use <Enter> to confirm selection of macros.
Pos: 121 /806-IHSE/zz_Layout/Seitenumbruch @ 8\mod_1348581820516_0.doc @ 69462 @ @ 1
