Imported by iiglo, Østre Kullerød 4,
N-3241 Sandefjord, Norway
Made in China | www.iiglo.com
Instruction manual for: IIFF269177IDD | IIFF269177BSDD
14
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person
must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Solution
Appliance does not work
Mains plug is not plugged in or is
loose
Insert mains plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
Appliance freezes or cools too much Temperature is set too cold or the
appliance runs at SUPER modes.
Turn the temperature regulator to a
warmer setting temporarily.
The food is not frozen enough.
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulation to a
colder setting temporarily.
The appliance is near a heat source. Please look in the installation
location section.
Heavy build up of frost on the door
seal.
Door seal is not air tight.
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time
shape the warmed door seal by
hand such thata it sits correctly.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall
or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
If necessary, carefully bend the
component out of the way.
Side panels are hot
This is normal. Heat exchanger is in
the side panels.
If the malfunction shows again, contact your point of purchase.
