Quick programming using Avelour
Installation guide
K0J00121
IJINUS - 25 ZA de Kervidanou 3, 29300 MELLAC - France - – Customer Service: +33 2 98 09 03 32 /
17
4
Maintenance
4.1
External antenna connection
Use only an external antenna provide by Ijinus.
Three lengths are available as standard: 1, 3 or 5m. In exceptional cases a length
of 10m can be proposed. Antennas are suitable for sewer network applications
with thick cable and reinforced sealing.
Important:
The antenna should be connected to the sensor by screwing it completely to ensure a good seal.
Identify the best antenna installation conditions, including the drilling direction for the best quality of
communication. A positioning and data sending test is available from the Avelour 6 software (described in section
3.6 of this document "sending data in GPRS"). This test is to be done before and after installation (closed manhole
cover).
4.2
Setting up a Sim card
Our sensors and loggers contain components that can be damaged by electrostatic discharge. Unload the body of
electrical charges before opening and handling the device.
Our sensors and recorders with integrated GSM / GPRS / 3G modem need a SIM card to work.
The following steps must be followed to ensure the correct operation of the sensor:
- The sensor must not be in radio communication with the software or connected via USB, in order to recognize
the SIM card.
- Unscrew the protective ring and remove the cover.
