Quick programming using Avelour
Installation guide
K0J00121
IJINUS - 25 ZA de Kervidanou 3, 29300 MELLAC - France - – Customer Service: +33 2 98 09 03 32 /
4
3.1
Necessary equipment
- The software Avelour in 6.7 version minimum
- Programing Wiji kit (with its cable and antenna)
or
Wiji key (USB/HF stick)
Software Avelour 6
Programming kit
Wiji Key (USB stick with RFID)
- The data logger LOG03V3 must be connected to the equipment using the provided cable. Wiring information
are presented below:
Male: Female:
Cable color
White
Brown
Green
Yellow
Grey
Pink
Blue
Red
Connector 8Pts
1
2
3
4
5
6
7
8
Signal
Vin
GND
Vout
Input
Input
Input
Input
Output
Open drain
(2A/30V)
Type
7V...30Vdc
Ground
7...30Vdc
Current 1
Current 2
Digital 1
Digital 2
Grounding
contact
Feature
Power in
Switch
4-20 mA
4-20 mA
1 or 0
1 or 0
Open drain
(1A/30V)
The output voltage of pin 3 can either comes directly from the input voltage using the internal switch or generated
by the logger from the internal power, this setting can be done using Avelour software. When using the internal
generator, the output voltage can be set using DIP switches. Below is the table of possible output voltage. the
default setting is 8,8V. If a different power supply is needed for the external sensor, it is possible to change
manually the switch code located on the bottom daughter board of the logger.