AmpliTube
X-DRIVE
34
CRUSH
This model alters the sound of the input signal by changing the sample-rate, cutoff frequency and by distorting
it. This effect can produce very aggressive distorted sounds, more pronounced than overdrive stomp boxes. The
low-pass filter is very creative when combined with high distortion levels.
Parameters
• DRIVE: increases the amount of clipping in the distortion circuit.
From 0 to 10.
• BASS: boosts and cuts the low frequencies.
From -6 dB to +6 dB.
• MID: boosts and cuts the mid frequencies.
From -6 dB to +6 dB.
• TREBLE: boosts and cuts the high frequencies.
From -6 dB to +6 dB.
• VOLUME: sets the output level.
From 0 to 10.
• CUTOFF: controls the cut-off frequency for the low-pass filter.
From 20 Hz to 20000.
• DECIM: selects the sample rate ratio of the processed sound.
From 1 to 15.
• MID Q: sets the bandwidth of the mid parameter EQ from narrow to wide.
From 0.2 to 3.
• MID FREQ: changes the center frequency of the mid parametric EQ.
From 80 Hz to 5000 Hz.
• EQ POSITION: sets the tone EQ pre or post clipping.
PRE or POST.
• NOISE GATE: turns the noise gate ON or OFF.
ON or OFF.
• NG THRESHOLD: adjusts the sensitivity of the gate’s threshold.
From -100 dB to 0 dB.
• NG RELEASE: adjusts the time of the gate’s release.
From 20 ms to 1500 ms.
• NG DEPTH: adjusts the gate’s deepness.
From -20 dB to -100 dB.
• COMPRESSOR: turns the compressor ON or OFF.
ON or OFF.
• COMP SENSITIVITY: sets the sensitivity of the compressor.
From 0 to 10.
• COMP OUT: sets the output level of the compressor.
From 0 to 10.
• CAB SIM: selects the cabinet simulator.
CAB 1, CAB 2, CAB 3, CAB 4, BASS, OFF.
