AmpliTube
X-SPACE
Reverb Models
15
HALL
This model recreates the ambience of a live concert hall with controlled decay and a reverb time range from 1
to 9 seconds to replicate from smaller venues up to larger clubs. With an advanced parameter set that features
a 3-band decay trimmer, the sound of the hall can be highly tweaked to always find the perfect tail in which to
place the instrument.
Parameters
• TIME: controls the reverb tail length.
From 1 s to 9 s.
• PRE-DELAY: controls the pre-delay amount.
From 0 ms to 1000 ms.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 to +10.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• HPF: controls the cut-off frequency of the high-pass filter.
From 22 Hz to 1000 Hz.
• MOD RATE: controls the rate of the reverb modulation.
From 0.1 Hz to 7 Hz.
• SIZE: controls the dimension of the ambience from which the reverb is generated.
From 50% to 150%.
• L DECAY: controls the low-frequency band decay.
From -10 to 10.
• M DECAY: controls the mid-frequency band decay.
From -10 to 10.
• H DECAY: controls the high-frequency band decay.
From -10 to 10.
• X-MODE: engages the most possible tail length.
ON or OFF.
