AmpliTube
X-SPACE
Reverb Models
27
SWELL
This is a swell processor that can automatically create fantastic fading swell effects followed by a customizable
reverb trail to create dreaming pads or string-like sounds.
Parameters
• TIME: controls the reverb tail length.
From 1 s to 4 s.
• PRE-DELAY: sets the length of the swell cycle.
From 10 ms to 3000 ms.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 dB to +10 dB.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• HPF: controls the cut-off frequency of the high-pass filter.
From 22 Hz to 1000 Hz.
• MOD RATE: controls the rate of the reverb modulation.
From 0.1 Hz to 7 Hz.
• SWELL DEPTH: sets the depth of the volume swell. By default, the depth is at max position, meaning that
the volume will start from silence. By lowering this control you’ll set the effect to start the swell phase from
a level which is higher than silence, up to min position that sets the effect to have no action.
From -90 dB to 0.
• SWELL SENS: this control sets the sensitivity for the swell to recognize a new note or chord and therefore
start a new swell cycle. Set it higher if you want the swell cycle to start even at the beginning of softer
passages or set it lower if you want the swell cycle to only start for louder strikes.
From 0% to 100%.
• X-MODE: engages the most possible tail length.
ON or OFF.
