AmpliTube
X-SPACE
Reverb Models
30
REVERSE
This model is perfect to create reverse delay trails that fade in while you are playing. The reverse envelope can
be set to 3 different modes to better fit the part.
Parameters
• TIME: controls the reverb tail length.
From 0% to 100%.
• PRE-DELAY: controls the pre-delay amount.
From 0 ms to 1000 ms.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 dB to +10 dB.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• TYPE: chooses from the three available reverse shapes to achieve the desired flavour.
From 1 to 3.
• SIZE: controls the dimension of the ambience from which the reverb is generated.
From 50% to 150%.
• MOD RATE: controls the rate of the reverb modulation.
From 0.5 Hz to 10 Hz.
• HPF: controls the cut-off frequency of the high-pass filter.
From 22 Hz to 1000 Hz.
• X-MODE: engages the most possible tail length.
ON or OFF.
