AmpliTube
X-TIME
Delay Models
11
Delay Models
VTG TAPE
This model is a classic tape echo with wobble effect that can be controlled and manipulated for experimental
lo-fi echo repeats, bringing extra creativity to any playing. It features all the typical tape echo characteristics and
nuances to bring a real tape sound under your feet.
Parameters
• TIME: controls the time of the delay repetitions.
From 60 ms to 1429 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the brightness of the delay repetitions. Turn it counterclockwise to have darker tones,
clockwise to have brighter tones.
From 0 to 10.
• MOD: controls the amount of wow & flutter happening in the tape echo.
From 0 to 10.
• MIX: Controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• X-MODE: the X-MODE pushes the tape echo feedback to its edge. The level increases until it is fully
saturated.
ON or OFF.
VTG TAPE Control Changes
Parameter
Control Change #
Values
TIME
21
0 – 127
FEEDBACK
22
0 – 127
FILTER
23
0 – 127
MOD
24
0 – 127
MIX
25
0 - 127
X-MODE
13
0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
