AmpliTube
X-TIME
Delay Models
16
PATTERN
This is the perfect model to find inspiration. It features 16 different delay patterns to experiment with and find
new rhythmic ideas.
Parameters
• TIME: controls the time of the delay repetitions. In BPM SYNC ON the options are:
• 0: the BPM time is divided by 4.
• 1: the BPM time is divided by 2.
• 2: the BPM time is kept as is.
• 3: the BPM time is multiplied by 2.
• 4: the BPM time is multiplied by 4.
From 125 ms to 2000 ms or from 0 to 4 when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the tilt filter amount. Turn it counterclockwise to filter out the high frequencies or clockwise
to get the full frequency spectrum.
From -20 dB to +20 dB.
• MOD: selects the pattern among the 16 available.
From 1 to 16.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• PAT FDBK: controls the number of repetitions of the whole pattern.
From 0% to 100%
• EQ HPF: sets the frequency for the high-pass filter.
From 22 Hz to 900 Hz.
• EQ LPF: sets the frequency for the low-pass filter.
From 500 Hz to 19800 Hz.
• EQ GAIN: sets the gain for the mid-band EQ.
From -20 dB to +20 dB.
• EQ FREQ: sets the frequency for the mid-band EQ.
From 100 Hz to 15000 Hz.
• EQ Q: sets the Q factor for the mid-band EQ.
From 0.1 to 10.
• X-MODE: the X-MODE pushes both feedback and pattern’s feedback to infinity.
ON or OFF.
