AmpliTube
X-TIME
Delay Models
18
DUAL
Two delays in one that can be set in series or in parallel to have an amazing stereo sound. The second delay
reacts on the first one, but with independent mix, feedback and time that is expressed in ratios of the first
delay’s time.
Parameters
• TIME: controls the time of the first delay repetitions.
From 60 ms to 2000 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the first delay.
From 0% to 100%.
• FILTER: controls the low-pass filter frequency. Turn it counterclockwise to filter out the high frequencies or
clockwise to get the full frequency spectrum.
From 800 Hz to 15000 Hz.
• MOD: controls the mix of the second delay.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• TIME 2: controls the time of the second delay expressed in ratios of the first delay.
• 1/8, 1/7, 1/6, 1/5, ¼, 1/3, ½, 1/1, 2/7, 2/5, 2/3, 2/1, 3/8, 3/7, 3/4, 3/2, 3/1, 4/7, 4/5, 4/3, 4/1, 5/7, 5/6, 5/4,
5/3, 5/2, 5/1, 6/7, 6/5, 6/1, 7/8, 7/6, 7/5, 7/4, 7/3, 7/2, 7/1, 8/7, 8/5, 8/3, 8/1.
• FDBK 2: controls the feedback for the second delay.
From 0% to 100%.
• MODE:
• SERIES: the two delays are placed in series.
• PARALLEL: the two delays are placed in parallel (one delay happens only on the left channel while the
other happens only on the right channel).
• X-MODE: the X-MODE pushes both feedbacks to infinity.
ON or OFF.
