AmpliTube
X-TIME
Delay Models
20
REVERSE
Amazing, reversed repeats that create wonderful delay tails. In addition to the reversed repeat, a non-reversed
repeat can be blended in to maintain the groovy part of the delay pattern.
Parameters
• TIME: controls the time of the delay repetitions.
From 63 ms to 2000 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the frequency response of the delay. Turn it counterclockwise to get darker tones or
clockwise for brighter sounds.
From 0 to 10.
• MOD: controls the volume of the non-repeated tap that can be added to the reversed one.
From 0 to 10.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• X-MODE: the X-MODE pushes the feedback to infinity.
ON or OFF.
REVERSE Control Changes
Parameter
Control Change #
Values
TIME
21
0 – 127
FEEDBACK
22
0 – 127
FILTER
23
0 – 127
MOD
24
0 – 127
MIX
25
0 - 127
X-MODE
13
0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
