AmpliTube
X-TIME
Delay Models
23
DUCK
A delay that makes it possible to have huge amounts of wet signal and feedback while retaining the dry signal
focused on top by ducking down the delayed signal every time the dry signal is played. The release can be
tweaked independently to add both slow and fast rises.
Parameters
• TIME: controls the time of the delay repetitions.
From 30 ms to 1450 ms or from 1/32 to 1/2T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the brightness of the delay. Turn it counterclockwise to get darker tones or clockwise get
the full frequency spectrum.
From 0 to 10.
• MOD: controls the ducking compressor threshold.
From -100 dB to 0 dB.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• RELEASE: controls the release of the ducking compressor.
From 20 ms to 3000 ms.
• X-MODE: the X-MODE pushes the feedback to infinity and makes the compression more aggressive.
ON or OFF.
DUCK Control Changes
Parameter
Control Change #
Values
TIME
21
0 – 127
FEEDBACK
22
0 – 127
FILTER
23
0 – 127
MOD
24
0 – 127
MIX
25
0 - 127
RELEASE
46
0 – 127
X-MODE
13
0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
