AmpliTube
X-TIME
Delay Models
29
DIRTY
Get dirty with this saturated and distorted delay for edgy repeats and aggressive tails. It also features a phaser
with independent speed and mix to really find the perfect grit and dirtiness in the delay lines.
Parameters
• TIME: controls the time of the delay repetitions.
From 60 ms to 2000 ms or from 1/32 to 1/2T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the low-pass filter frequency. Turn it counterclockwise to get darker tones or clockwise get
the full frequency spectrum.
From 790 Hz to 20000 Hz.
• MOD: controls the dry/wet for the phaser effect.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• DIRT: pushes the input to the delay increasing the distortion effect.
From 0 dB to +40 dB.
• SPEED: controls the speed of the phaser effect,
From 0 to 10.
• X-MODE: the X-MODE pushes the feedback to infinity.
ON or OFF.
DIRTY Control Changes
Parameter
Control Change #
Values
TIME
21
0 – 127
FEEDBACK
22
0 – 127
FILTER
23
0 – 127
MOD
24
0 – 127
MIX
25
0 - 127
DIRT
46
0 – 127
SPEED
47
0 - 127
X-MODE
13
0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
