AmpliTube
X-TIME
Delay Models
31
ARCTIC
This delay is full of lush and never-ending tails. The delay is sent to a flanger and then to a shimmer with a
customizable pitched voice to get very modulated and ethereal in any shape of form. This creates very modern
delay trails great for ambient sounds.
Parameters
• TIME: controls the time of the delay repetitions.
From 62 ms to 1092 ms or from 1/32 to 1/2T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the brightness of the delay. Turn it counterclockwise to get darker tones or clockwise get
the full frequency spectrum.
From 0 to 10.
• MOD: controls the mix for the flanger effect.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• SHIMMER: controls the amount of shimmer reverb wetting the delay.
From 0 to 10.
• SIZE: controls the size of the shimmer reverb and the timing of the shift effect.
From 0 to 10.
• SHFT VOL: controls the volume of the shift effect.
From 0 to 10.
• SHIFT: sets the pitch for the shift effect.
From -12 semitones to +12 semitones.
• X-MODE: the X-MODE pushes the feedback to infinity and the reverb size and mix to max.
ON or OFF.
